Center for Quantum Devices - Most Downloaded Journal Articles

Page 30 of 30: Prev << 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 (736 Items)

3.	Room Temperature Epitaxy of Ni1−xMgxO on c Plane Sapphire by Plasma Assisted Pulsed Laser Deposition David J. Rogers, Eric V. Sandana, Ferechteh H. Teherani, M. Razeghi physica status solidi (b) 2026, 263 (7), e202500648. ...[Visit Journal] This paper reports on room-temperature (RT) epitaxial growth of NiO and Ni1-xMgxO (x ≈ 0.50) thin films on c-plane sapphire (0001) using plasma-assisted pulsed laser deposition. Optical transmission reveals absorption edges at ~3.6 eV (NiO) and ~4.4 eV (Ni0.5Mg0.50O), confirming bandgap engineering via Mg incorporation consistent with prior alloy data. X-ray reflectivity (XRR) indicates smooth surfaces and thicknesses of ~60 nm (NiO) and ~65 nm (Ni0.5Mg0.50O). High-resolution X-ray diffraction 2θ/ω scans indicate fcc (111) orientation for both films; ω-rocking curves exhibit full width half maxima of 0.07°—remarkably low mosaic spread for RT-grown oxides. (002) pole figures display six-fold symmetry, evidencing epitaxial relationships featuring two rotational domains (±60°) about [111] on c-sapphire. AFM (1 µm × 1 µm) yields root mean square roughness of ~0.5 nm (NiO) and ~2.6 nm (Ni0.5Mg0.50O). Four-point probe gives ρ ≈ 26 Ω·cm (NiO) and insulating behavior for Ni0.5Mg0.50O, consistent with bandgap widening and reduced hole concentration. These results establish RT epitaxial Mg-alloyed NiO with exceptional crystallinity, directly relevant to Ga2O3 heterojunctions for power electronics and solar-blind ultra violet C-band photodetectors, where tunable band alignment and sharp interfaces are critical.
3.	Improved performance of quantum cascade lasers through a scalable, manufacturable epitaxial-side-down mounting process A. Tsekoun, R. Go, M. Pushkarsky, M. Razeghi, and C. Kumar N. Patel Proceedings of the National Academy of Sciences 103 (13)-- March 26, 2006 ...[Visit Journal] We report substantially improved performance of high-power quantum cascade lasers (QCLs) by using epitaxial-side-down mounting that provides superior heat dissipation properties. We used aluminum nitride as the heatsink material and gold–tin eutectic solder. We have obtained continuous wave power output of 450 mW at 20°C from mid-IR QCLs. The improved thermal management achieved with epitaxial-side-down mounting combined with a highly manufacturable and scalable assembly process should permit incorporation of mid-IR QCLs in reliable instrumentation.
3.	Novel Green Light Emitting Diodes: Exploring Droop-Free Lighting Solutions for a Sustainable Earth M. Razeghi, C. Bayram, R. McClintock, F. Hosseini Teherani, D.J. Rogers, and V.E. Sandana Journal of Light Emitting Diodes, Vol. 2, No. 1, p. 1-33-- April 30, 2010 ...[Visit Journal] The total annual energy consumption in the United States for lighting is approximately 800 Terawatt-hours and costs $80 billion to the public. The energy consumed for lighting throughout the world entails to greenhouse gas emission equivalent to 70% of the emissions from all the cars in the world. Novel solutions to lighting with higher efficiency will drastically reduce the energy consumption and help greenhouse gas emissions to be lowered. Novel green light emitting diodes are the key components of an affordable, durable and environmentally benign lighting solution that can achieve unique spectral quality and promise superior energy conversion efficiency. Light-emitting diodes (LEDs), based on the InGaN alloy, are currently the most promising candidates for realizing solid state lighting (SSL). InGaN is a direct wide bandgap semiconductor with an emission that can span the entire visible spectrum via compositional tuning. However, InGaN LED performance remains wavelength-dependent. Indeed, ultrabright and efficient blue InGaN-based LEDs are readily available but the performance of InGaN-based green LEDs is still far from adequate for use in SSL. Our recent work demonstrated hybrid green light-emitting diodes (LEDs) comprised of n-ZnO/(InGaN/GaN) multi-quantum-wells/p-GaN were grown on semi-insulating AlN/sapphire using pulsed laser deposition for the n-ZnO and metal organic chemical vapor deposition for the other layers.. We have shown that atop grown ZnO layer by Pulsed Laser Deposition can be a good replacement for GaN. The green wavelength emission requires significant indium content in the active layer (growth temperature ~ 700ºC) that makes InGaN quantum wells very susceptible to thermal degradation. With our technology, diffusion and segregation of indium in the green emitting active is inhibited thanks to the lower ZnO deposition temperatures (<600ºC) than is required for GaN (>1000ºC). Our novel technology preserves the integrity of the as-grown active layer and demonstrates superior green spectral quality (as demonstrated for LEDs on c-sapphire). The results indicate that hybrid LED structures could hold prospects for the development of green LEDs with superior performance.
3.	Study of Au coated ZnO nanoarrays for surface enhanced Raman scattering chemical sensing Gre´gory Barbillon, Vinod E. Sandana,Christophe Humbert, Benoit Be´lier, David J. Rogers, Ferechteh H. Teherani, Philippe Bove Ryan McClintock and Manijeh Razeghid J. Mater. Chem. C, 2017, 5, 3528-- March 20, 2017 ...[Visit Journal] At present, the simultaneous attainment of good reproducibility and high enhancement factors (EF) are key challenges in the development of surface enhanced Raman scattering (SERS)substrates for improved chemical and biological sensing. SERS substrates are generally based on distributions of metallic nanoparticles/structures with different shapes and architectures which are prepared by either thermal dewetting, precipitation from colloidal suspensions1–4 or advanced (e.g. deep UV or electron beam (EBL)) lithographic techniques.5–9 Although such substrates can exhibit large Raman enhancements, the former two techniques (colloidal and thermal dewetting) give poor SERS reproducibility while deep UV and EBL are too expensive and/or complex for mass production.
3.	Nitrides push performance of UV photodiodes Can Bayram; Manijeh Razeghi Laser Focus World. 45(9), pp. 47-51 (2009)-- September 1, 2009 ...[Visit Journal] The nitrides are known to be useful for creating the UV single-photon detectors with efficiencies of 20%, with its considerable advantages that could further enable quantum computing and data encryption. Such detectors would be well suited for numerous applications in the defense, commercial, and scientific arenas, including covert space-to-space communications, early missile-threat detection, chemical and biological threat detection and spectroscopy. The use of SAM regions is a common approach to reducing multiplication noise and enhancing gain through impact-ionization engineering that could benefit from the higher ionization coefficient by offering lower noise performance and higher gain. The ADPs also enables the realization of single-photon detection by using Geiger-mode operation, which entails operating the ADPs well above the breakdown voltage and using pulse-quenching circuitry.
2.	-- November 30, 1999
2.	-- November 30, 1999
1.	-- November 30, 1999
1.	-- November 30, 1999
1.	-- November 30, 1999
1.	-- November 30, 1999

Page 30 of 30: Prev << 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 (736 Items)